You can enable/disable and configure the Face Recognition function in this menu and the web interface. You can add face identifiers in the web interface (Identifiers tab).
Use the Up/Down arrows or the 2/8 buttons on your keypad to move between menus and fields. To confirm press the # button, and * if you need to go back.
...
- enable/disable the feature;
select similarity level (the lower the similarity level, the greater the error can be in scanning a face and granting access):
- low: the minimal similarity is necessary for access (changes in appearance (glasses, beard, presence of a hat) will not be taken into account);
- normal: some changes in appearance are taken into account, but not detailed (recommended for homes and offices);
- high: the maximum similarity is necessary for access (recommended for high-security places);
select the appropriate mode:
- software: the software recognition algorithm is used, and there is a possibility of giving access by photos;
- anti-spoofing: more detailed software recognition algorithm is used to prevent access by photos;
- 3D (is available for panels with a built-in 3D sensor): detailed face recognition using IR sensors and building a face heat map to prevent spoofing;
- turn on/off automatic face recognition when motion is detected. When a person approaches a panel (at a distance up to 50 cm) motion sensor becomes active, and a panel will exit standby mode and turn on the face recognition feature.register new face to the panel memory;
...
...
We recommend adding a face ID by uploading photos via the web interface, because faces added using the method below will not be displayed in the web interface of the panel, so it will be impossible to link it to a user.
How to add face ID via the graphical interface
1. In the Register column, press # and enter any number.
2. Press # again and stand in front of the camera for scanning.
3. After a beep, the face will be added to the panel memory.
- delete all previously added faces.
