You can configure SIP settings in the section for correct SIP server functioning. After changing any settings, click Confirm at the end of the page.
| Table of Contents |
|---|
SIP status
Here you can monitor SIP proxy and SIP node statuses. Click
to refresh the service.
...
SIP settings
In this section, you can cofigure the SIP server. You must enter the following:
...
| Info |
|---|
All ports require forwarding if the server is behind NAT. |
...
Network interfaces
The value of the server external IP address is not required if the Link system is not complex and the server is not behind NAT. If the fields are left blank, the value of the server IP address will be used for them.
...
the server is behind NAT and one NIC is used. In this case, the IP address of the network card must be entered in both fields;
the server is behind NAT and 2 network cards are used:
for the internal network in which the door phones are located;
for the external network through which the server connects to the Internet.
...
Internal subnets
You must enter the address of the subnets in which intercoms and SIP applications of users are connected. The record format is subnet address/mask bit value, for example, 192.168.1.0/24.
...
SIP nodes
These settings are required to fill if the container(s) of the SIP nodes are deployed on another server.
...
If a separate server with a node is not behind NAT, then you must specify the external IP address of the node in both fields.
...
Additional SIP functionality
Here you can enable the feature of automatic creation of forward rules for apartment group user/s, sending them to device/s (if some devices are added/deleted the corresponding data will be added/deleted to/from devices), and data correction for device/s (if there are some changes in virtual numbers or logical address).
...
Also, you can delete all created forwarding queues from the server and devices.
...
Used ports
The application uses the following ports:
...