...
sync code between monitors.
...
SIP
| Widget Connector | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
The SIP settings are required for the monitor to work via the SIP protocol. If you use the BAS-IP Link server we recommend configuring SIP settings remotely using the Link (via MQTT protocol) and then sending them to the device.
...
If the connection with the SIP server is lost, it will be automatically renewed. You can set the re-registration interval (30-900 seconds) between attempts to renew the connection.
...
DTMF settings
| Widget Connector | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
In the menu, you can configure the DTMF code, entering which the lock will be opened. Code length is up to 4 characters.
...
enabling/disabling all incoming calls autoanswer;
enabling/disabling auto hung up after pressing the Open button during a call;
setting the delay time after pressing the Open button before opening the lock;
speaker volume adjustment during a conversation (talk volume);
general volume adjustment;
setting the conversation maximum time.
...
Call forwarding
| Widget Connector | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
With this feature, you can connect up to 4 devices that will receive calls simultaneously with a call to the internal monitor.
...
For the feature operation, you must enable the multicast paging and provide an IP address and port that the monitor must listen to get notifications.
...