Below are general BAS-IP lift controller connection schemes:
| Table of Contents |
|---|
https://www.youtube.com/watch?v=hO3YdAL-H6s
Connection to the Call buttons located on the floors, or connecting to the centralized input module responsible for calling the elevator to the
...
floors.
| Info |
|---|
This connection is used to simulate pressing the floor buttons in the Call Up/Down mode. |
...
Connection to elevator buttons on lift car
...
keypad.
| Info |
|---|
This connection is used in the Access Control Manual mode, where EVRC ports are linked to the floor buttons inside the elevator to simulate their pressing. |
...
Connection directly to the elevator controller or cross
...
equipment.
| Info |
|---|
This connection is used to interface EVRC with the elevator control system, allowing it to simulate button presses for floor calls or inside the elevator as required by the selected mode. |
...
Connection for Using the Two-Step Mode of EVRC-IP
...