...
Check that the equipment does not have external defects. To organize the connection of the system, prepare:
Network cable (UTP CAT5 or higher);
Two-core cable (minimum cross-section 0.205 mm or 24 AWG);
Power supply 48 V DC (please check cable length, specification, and connection status);
2.0 / 2.5 mm slotted screwdriver.
2. Installation
The SW-02 converter has two interfaces: the LAN interface can be connected to the Internet, and the other interface is connected to a 2-wire system.
The panel is connected to a two-wire system through the SW-02 converter on one side and to the local network on the other (it is also possible to connect the patch cord directly to the internal monitor).
Connect the 48 V DC power supply to the SW-02 to provide power to the entire system, including the internal monitor (converters and switches support power transmission over PoE IEEE 802.3 af and at).
All devices are in 2Wire Link mode. They will find each other and establish basic low-level encryption.
...
To show the operating status of the device, the converter has three LEDs:
Power: The red LED is always on;
Two-wire connection: if the green LED is always on, it means that 2Wire Link mode is active. If the LED blinks slowly, it means the 2Wire Unlink mode is active;
LAN: green LED - Ethernet connection indicator. When the module transmits or receives data via Ethernet, the LED flashes
with a period offor 250 ms.
Typical schemes for connecting system components
When using this system, the connection of internal monitors can be carried out both on the same local network and using two-wire wiring.
System with individual panel:
System with multi-apartment panel:
| Widget Connector | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
A system with the individual panel
...
A system with a multi-apartment panel
...