/
Access settings

Access settings

You can open basic settings from a panel or a web interface. To enter the system settings, you must press the 📞 button twice (the inscription Admin will appear on the screen). Then enter the admin password you created when first setting up the device or after a factory reset, and press 📞 to confirm. This will open the settings menu.

Use the Up/Down arrows or the 2/8 buttons on your keypad to move between menus and fields. To confirm press the 📞 button, and X if you need to go back.

In this menu, you can set: 

  • Lock open timeout is a period (1-300 sec) during which relay contacts will be closed or open (depending on the lock type), and a lock will stay open;

  • Lock open delay is a period (1-300 sec) after which relay contacts will close or open after sending a signal to open a lock;

  • Floor number (Elev Refer) where the panel is installed for further lift control module EVRC-IP use (optional).

  • Password (no more than 8 characters) is a general code entered on a panel keypad to open a lock. The default password is 0000.