Elevator management

This section is for EVRC-IP elevator controllers management and configuration. EVRC-IP allows users to call the elevator to the required floor from the monitor or Link app, to call the elevator to the ground floor for visitors, and to call it when bringing identifiers to the panel reader. Also, there is an opportunity to configure access to selected floors for each identifier.

An elevator controller must be connected to the devices system and configured for operation with the Link server. 

Сonfiguration from the EVRC-IP side 

  1. Log in to the device web interface. By default, the username is admin, and the password is 123456.

  2. Go to the Network tab > Management system section.

  3. Activate the Use of the BAS-IP Link server

  4. Enter an IP address or domain name of the server where the Link software is installed.

  5. Provide device password to Link server.

  6. If necessary, you can activate sending of real-time logs and heartbeat (current status: online/offline) from the elevator controller to the server. 

  7. Submit settings. 

The following links contain information about the main steps of Link server configuration for operation with the EVRC-IP elevator controllers: