...
- Type: RTSP
- IP address: rtsp://admin:123456@192.168.88.161:8554/ch01
192.168.88.161 - IP address of your BAS-IP device - Port: 8554
- Name: admin
- Password: 123456
. Right-click on the Video capture device to open the menu, and select Create object and Camera.
...
. Right-click on LOCALHOST to open the menu, and select Create object and Video capture device again with next parameters.
Where:
- Type: SIP
- IP addres address of your BAS-IP device
- Port: 5060
. Right-click on the Video capture device to open the menu, and select Create object and Sensor, it automaticaly fill parametes.
...
. Right-click on LOCALHOST to open the menu, and select Create object and Audio card.
. Type the Name for the Audio card and press Apply.
. Selecr Select Board: IpCam RTSP
. Right-click on Audio card to open the menu, and select Create object and Microphone.
. Selecr Select Channel: IpCam RTSP
. Go back to the Camera created in step 9 and set the Recording audio parameters. You can check if the video is working by pressing the Video button.
????. Right-click on Audio card to open the menu , and select Create object and Microphone again, and set up parameters.
.
. In the same way, as described in steps 10 - 14 create an Audio card and Microphone for operator the operator.
. Right-click on LOCALHOST to open the menu , and select Create object and Intercom Subsystem.
. Right-click on Intercom Subsystem to open the menu and select Create object and Intercom.
. Parameters must correspond with objects that were created earlier, if not change them
????????. At this step there must be created:
- Video capture device with a camera
- Video capture device with a sensor
- Audio card for panel with microphone
- Audio card for panel with a virtual microphone
- Audio card for the operator with a microphone
- Intercom subsystem with intercom
. Goto Interfaces tab, right-click on Display to open the menu, and select Create object and Audio player.
. Press the All button to add microphones.
. Right-click on Display to open the menu and select Create object and Monitor.
. In the List of cameras add created earlier camera.
. Right-click on Display to open the menu and select Create object and Inercom Control Monitor.
. Set up Server, Position, and Microphone
