| Table of Contents |
|---|
| Widget Connector | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
To make a call between a panel and an indoor video entry phone (monitor) by pressing the button of the required apartment or entering its number, the panel and the monitor must have the same building and unit number in apartment settings. Also for monitors, you must indicate corresponding information about the floor, apartment, and device number.
...
During a call, the entrance panel checks its forwarding queue only when it fails to find any monitors according to the entered values of the building, unit, floor, and apartment. If you want to enable the Forwarding from the beginning (without searching the corresponding monitor via the internal protocol), you need to set different logical addresses for the panel and the monitor. For a detailed explanation of the correct logical address configuration, please refer to the Forwarding from the entrance panel article.
...
all at once: the call is made to all numbers simultaneously.
one by one: the call is made to the numbers in turn with a 20 seconds -second delay.
...
| Warning |
|---|
If you have an analog and IP device in the same queue, the All at once mode do not work. |
...
| Info |
|---|
Format for calls via P2P: Two formats for numbers are available:
Format for calls to SP-02 is:
Format for calls via SIP:
You can also use the short form and enter only the callee SIP number of the called device ("sip:" at the beginning and the SIP server address can be skipped). So, it is enough to enter 5588. For the forwarding correct function, the SIP numbers in one queue must be registered on the same SIP server. For example, forwarding will work for your SIP numbers registered on the us.sip.bas-ip.com server. Format for calling the handset of a digital two-wire system:
Format for calling the handset of a coordinate matrix system:
|
...