| Table of Contents |
|---|
...
subnet mask;
the main gateway;
DNS server address;
...
Wi-
...
Fi settings (available for SP-03F)
In this section, you must set network data for the monitor when it is connected to the network via Wi-Fi. You can turn on/off the DHCP connection and get available network settings automatically or enter it manually.
...
| Info |
|---|
When your monitor is connected to the network via Wi-Fi, the device will have settings specified in the Wi-fi Fi settings, i.e., you can access the device web interface with the IP address indicated in this section (for example, 192.168.1.107). But if the Wi-Fi connection is disabled, data from the Network section will be used (e.g., the monitor interface will be available at the 192.168.1.75 address). |
...
Using the automatic setting of time, data will be automatically synchronized with a server via the Internet. Therefore, this option requires an Internet connection. To configure server work, complete the steps:
Tick the Set time automatically box.
Enter the URL or IP address of the server that is used for synchronization.
Choose the required timezone.
Submit changes.
...
If you need to get the current state of the MQTT client, go to System > Debug Support.
...
| Info |
|---|
For correct functioning, the MQTT protocol is required settings from the management system side. See for details. |
...
If necessary, you can activate sending real-time logs and heartbeat (current status: online/offline) from the panel to the server.
...
Device initialization
You can prepare some configurations on the Link server and apply them to the device. Step-by-step initialization guide you can find here.