After verifying the device completeness, you can proceed to the monitor connection.
For connection you need:
an Ethernet UTP CAT5 or higher cable connected to a network switch/router;
The maximum length of the UTP CAT5 cable segment should not exceed 100 meters, according to the IEEE 802.3 standard.
power supply at + 12V, 2 Amps;
wires must be brought for connecting the lock and additional modules (optional).
Here are typical connection schemes:
- Connection using the siren output as a controlled output with an external additional relay, to control devices or any other load with high power consumption
- Connection using various types of buttons connected to alarm loops, and using them as bell buttons
- Connection of security alarm sensors with NC (normally closed) contact types
- Connection of security alarm sensors with NO (normally open) contact types
- Connection of security alarm sensors with NC (normally closed) contact types using SH-16 module
- Connection of security alarm sensors with NO (normally open) contact types using SH-16 module
Connection using the siren output as a controlled output with an external additional relay, to control devices or any other load with high power consumption
Connection using various types of buttons connected to alarm loops, and using them as bell buttons
Connection of security alarm sensors with NC (normally closed) contact types
Connection of security alarm sensors with NO (normally open) contact types
Connection of security alarm sensors with NC (normally closed) contact types using SH-16 module
Connection of security alarm sensors with NO (normally open) contact types using SH-16 module
