/
Electrical connection
Document toolboxDocument toolbox

Electrical connection

Owned by BAS-IP (Unlicensed)
Last updated: Jan 11, 2024
2 min read

After verifying the device completeness, you can proceed to the monitor connection.

To connect the monitor you need: 

  • an Ethernet UTP CAT5 or higher cable connected to a PoE switch or to a normal switch/router; 

The maximum length of the UTP CAT5 cable segment should not exceed 100 meters, according to the IEEE 802.3 standard.

  • power supply at +12 Volts DC if there isn't PoE;

  • wires must be brought for the connection of alarm loops and home automation (optional);

Here are typical connection schemes:

Connection using the siren output as a controlled output with an external additional relay, to control devices or any other load with high power consumption 

Connection using various types of buttons connected to alarm loops, and using them as bell buttons 

Connection of security alarm sensors with NC (normally closed) contact types 

Connection of security alarm sensors with NO (normally open) contact types 

Connection of security alarm sensors with NC (normally closed) contact types using SH-16 module

Connection of security alarm sensors with NO (normally open) contact types using SH-16 module

Related content