Electrical connection

Owned by Vladislav Turzai
Nov 08, 2024
2 min read

After verifying whether a device is complete, you can switch to the connection step.

For connection you will need:

  • An Ethernet UTP CAT5 or higher cable connected to a network switch / router.

The maximum length of the UTP CAT5 cable segment should not exceed 100 meters, according to the IEEE 802.3 standard.

  • power supply at + 12V, 2 Amps, if there is no PoE.; 

  • Wires must be brought for the connection of exit button, fire alarm, door sensor and lock.

You can connect any type of electromechanical or electromagnetic lock for which the switched current does not exceed 2 amps.

The following are typical connection schemes of all elements to the entrance panel:

Connection scheme of electromechanical lock using external power supply for panel and the lock.

image-20241108-130010.png

Connection scheme of electromechanical lock using PoE for panel and additional power supply for the lock

image-20241108-130142.png

 

Connection scheme of electromagnetic lock using external power supply for panel and the lock.

 

Connection scheme of electromagnetic lock using PoE for panel and additional power supply for the lock