...
During a call, the entrance panel checks its forwarding queue only when it fails to find any monitors according to the entered values of the building, unit, floor, and apartment. If Suppose you want to enable the Forwarding from the beginning (without searching the corresponding monitor via the internal protocol). In that case, you need to set different logical addresses for the panel and the monitor. For a detailed explanation of the correct logical address configuration, please refer to the Forwarding from the entrance panel article.
...
Log in to the entrance panel web interface. By default, the username is admin, the password is 123456.
Open the Forward tab and click New Forward.
Enter your the Apartment Number which consists of the floor and room number. For example, 223 indicates apartment 23 located on the 2nd floor. Entering this number on the panel the queue will work.
...
for which you are configuring forwarding.
For BI panels values of floor and apartment are hardcoded for each button. The floor parameters are always equal to 0. The apartment number corresponds to the button number, so the 1st button will call apartment number 1, while the 12th button will call apartment number 12.
Enter the Forward Number (directions for call forwarding). You can add up to 8 numbers for forwarding. Calls can be made both via P2P and via the SIP protocol.
...