Electrical connection

After checking the completeness of the device, you can proceed to the connection.

To connect you will need:

Ethernet cable UTP cat5 or higher connected to a network switch / router.

Cable lenght recomendations

The maximum length of a UTP CAT5 cable segment must not exceed 100 meters, according to the IEEE 802.3 standard.

To connect the panel via PoE, you need to use a switch that works with 802.3 af support with a maximum power per port of no more than 15.4 watts.

When connecting the panel panel by PoE,it is prohibited to power the lock using panel's power. You must use a separate power supply, otherwise it may cause damage to the device.

Power supply at +12 Volt, 2 Ampere.
Wires must be brought for connecting the lock and additional modules (optional).

You can connect any type of electromechanical or electromagnetic lock for which the switched current does not exceed 5 Amps.

Below is the designation of all contacts on the panel.

Pin assignment on the outdoor panel:

GND: Ground.

12V: Power supply + 12 Volts.

485A: RS485 Data +.

485B: RS485 Data -.

DoorA-DoorE: Controlled inputs (dry contacts). It is possible to use for connecting the exit buttons and door sensors, and fire alarm sensors as well, if connected to the corresponding bus.

GNDA-GNDE: Ground for controlled inputs.

D0: Contact Data 0 for Wiegand.

D1: Contact Data 1 for Wiegand.

GND: Ground for Wiegand.

GND: Ground for locks.

R_A_NO: Normally open contact for 1 relay.

R_A_COM: Switchable contact for 1 relay.

R_A_NC: Normally closed contact for 1 relay.

R_B_NO: Normally open contact for 2 relay.

R_B_COM: Switchable contact for 2 relay.

R_B_NC: Normally closed contact for 2 relay.