Connection scheme

Below are general BAS-IP lift controller connection schemes:

Connection to the Call buttons located on the floors, or connecting to the centralized input module responsible for calling the elevator to the floors. This connection is used to simulate pressing the floor buttons in the Call Up/Down mode.

Open

Connection to elevator buttons on lift car keypad. This connection is used in the Access Control Manual mode, where EVRC ports are linked to the floor buttons inside the elevator to simulate their pressing.

Open

Connection directly to the elevator controller or cross equipment. This connection is used to interface EVRC with the elevator control system, allowing it to simulate button presses for floor calls or inside the elevator as required by the selected mode.