Home
Spaces
Apps
Templates
Create
FAQ
All content
Space settings
Content
Results will update as you type.
General questions
Questions about indoor video entry phones (monitor)
Questions about panels
•
How to change the Wiegand type of panel reader?
•
How to configure a simultaneous call from a panel to 2 concierge terminals via P2P?
•
How to configure the AV-04AFD entrance panel to make emergency calls to rescue services?
•
How to configure two locks control at an entrance panel?
•
How to configure two-way video during the call
•
How to customize sounds at multi-apartment entrance panels?
•
How to set up and use UKEY to open two locks?
•
How to factory reset an RFID reader of entrance panels?
•
How to make AV-07B/T dictate its IP address?
•
How to take incoming calls from an panel to a smartphone through the Internet anywhere in the world? What’s required?
•
Is it possible to connect an individual entrance panel with a monitor directly, without a network switch?
•
Is it possible to connect an IP camera to the entrance panel for license plates scanning?
•
Is it possible to install a network reader with an embedded controller CR-02BD or an entrance panel outside?
•
Is it possible to transfer Face ID to third-party readers or PACS (Access Control) via the Wiegand interface?
•
What card formats do BAS-IP panels compatible with?
•
What individual entrance panels have the Wiegand interface?
•
What to do if a panel reads keychains SH-02 with the same code while adding them as identifiers?
•
What to do if I can not import identifiers from the backup to multi-apartment entrance panels?
•
What to do if the video before the answer does not work at АV-07В/Т after the firmware update?
•
Can I get the video during the call from panel to IP phone?
•
What is the maximum length of wires connected to RS485+ and RS485- contacts?
•
What SIP protocol version is used?
•
What audio codecs are supported?
•
What video codec is supported?
•
How is DTMF transmitted?
•
What signaling ports are used?
•
What is the range of RTP ports used?
Questions about accessories
Questions about BAS-IP services and software
Questions about mobile apps (Link, Intercom, UKEY)
FAQ
/
Questions about panels
/
What signaling ports are used?
What signaling ports are used?
Vladislav Turzai
Owned by
Vladislav Turzai
Dec 23, 2024
1 min read
Loading data...
For
UDP/TCP
, port
5060
is used.
For
TLS
, port
5061
is used.
{"serverDuration": 44, "requestCorrelationId": "13f7c999445f44118fd8f091829c4fb4"}